Grey ABS plastic case in ten sizes to take electronic circuit boards. The top has a recess for labels and or membrane keypads.  The same recess is on the bottom of the enclosure.  There are internal pcb mounting pillars on both top and base of the enclosure (pcb mounting screws are supplied).  The enclosures are fixed by four small countersunk self-tapping screws (supplied)(you will need a No.0 screwdriver).  The material ABS is flame retardant according to UL94 V-0.

The simple plastic electronics box above is the same base with a different lid.

Grey water-resistant ABS plastic case in eight sizes to take electronic circuit boards. The top has a recess for labels and or membrane keypads.  There are internal pcb mounting pillars on the base of the enclosure (pcb mounting screws are supplied).  The enclosure lids are fixed by four pan-head machine screws (supplied).  The material ABS is flame retardant according to UL94 V-0.  IP65 waterproofing is via user-fitted O-ring (supplied).

The clear top enclosures below are the same base with a clear ABS lid, and the polycarbonate enclosures below that are the same as these with a better type of plastic.

Most of these electronic enclosures are "deep box with thin lid" as shown in the photograph here, but two are "hi-top" shown in the photograph for the clear top range below.

Grey water-resistant ABS plastic case with clear top to take electronic circuit boards in the same eight sizes as the standard waterproof enclosure above. The top has a recess for labels.  There are internal pcb mounting pillars on the base of the enclosure (pcb mounting screws are supplied).  The enclosure lids are fixed by four pan-head machine screws (supplied).  The material ABS is flame retardant according to UL94 V-0.  IP65 waterproofing is via user-fitted O-ring (supplied).

The waterproof enclosures above are the same base with a matching colour (non transparent) lid, and the polycarbonate enclosures below are the same as those above with a better type of plastic.

Most of these electronic enclosures are "deep box with thin lid" as shown in the photograph for the waterproof range above, but two are the "hi-top" style shown in this photograph

Grey water-resistant polycarbonate plastic case in eight sizes to take electronic circuit boards. The top has a recess for labels and or membrane keypads.  There are internal pcb mounting pillars on the base of the enclosure (pcb mounting screws are supplied).  The enclosure lids are fixed by four pan-head machine screws (supplied).  The material ABS is flame retardant according to UL94 V-0.  IP65 waterproofing is via user-fitted O-ring (supplied).

This polycarbonate range of enclosures is more expensive than the physically identical ABS ranges above.  Polycarbonate has better impact resistance and resists breakdown by UV rays (sunlight).

Most of these electronic enclosures are "deep box with thin lid" as shown in the photograph here, but two are "hi-top" shown in the photograph for the clear top range above.

Grey polycarbonate plastic wall mounting brackets supplied in a pack of four with four screws for fixing to the waterproof box, four wall fixing plugs and self tapping wall screws to go in them.  The material ABS is flame retardant according to UL94 V-0.

A location pip on the lug fits into a recess in the base at each corner of the enclosure and a the supplied self tapping screw goes into a suitably located boss in the enclosure.  In this way, fixing the bracket on the enclosure does not compromise the waterproofing.

Some enlarged views of the electronic enclosure wall-mounting brackets.