E-Case B is our most popular extruded enclosure
E-Case B electronic enclosure is designed for Eurocard width circuit boards. It is a box section extruded enclosure to take a 100mm wide board with board lengths 80mm, 160mm or 220mm. It is also available in non-standard lengths. Standard colours are silver anodized or black anodized (which is slightly more expensive). The silver anodized finish has bare aluminium where the ends of the extrusion have been cut. The black anodized finish covers the complete surface of the box. Non-standard anodised colours are also available.
The circuit board can have components 18 or 20mm high (depending on orientation). Fig.1 shows the the pcb with maximum component height on it of 18mm. This pcb will fit in the bottom groove of the box orientated as in Fig.2. The pcb slides in grooves 2mm deep down either side of the box. This means that approximately 2.5mm is unavailable for components on each side. The useable part of the pcb is a strip 95mm wide in the middle.
The top of the box features a shallow (0.5mm) recess between the decorative grooves which will take a label. The dovetails down the sides will take a Linc-lug wall mounting bracket (2 lengths available). Two lengths of Linc-lug are available. There is an optional gasket set to aid waterproofing, and an optional bezel which is black. Fig.2 shows the silver anodised extruded enclosure with Linc-lugs LSS40 (40mm long). Bezels ZBB1 have been fitted. Gasket set GB1 may also be fitted, but it will be hidden by the bezel. Optional end plates PBS1 can be taken with this box, but Fig.2 shows a non-standard endplate printed and punched to customer specification.
Exterior dimensions of the aluminium extruded enclosure are 108.5mm x 30mm with a variable length. Generally the order code for the box designates the length of the circuit board to go inside. For example EBS80 is the order code for an extruded enclosure that is approximately 80.5mm long to take an 80mm board.
DOWNLOADS & PRODUCT DETAILS
|E-Case A||E-Case C|